10000W超大功率可控矽電子調壓器 110V-220V電機馬達控制調速調光

-6%

10000W超大功率可控矽電子調壓器 110V-220V電機馬達控制調速調光

NT$930 NT$870 (未稅)

Availability: 客訂商品無現貨 貨號: IOT-006818 分類: 標籤: , , , , , ,

描述

10000W超大功率可控矽電子調壓器 110V-220V電機馬達控制調速調光

10000W超大功率可控矽電子調壓器 ,配智慧風扇,標配鋁外殼安全耐用 超大功率 電子調壓器,適用於燈光工程彩燈控制,電熱絲、鍋爐加熱控制,電動工具馬達等控制,此產品電路設計極為先進,觸發精確控制,用料好,是你值得擁有的一款調壓器。

10000W超大功率可控矽電子調壓器

產品特色

  1. 觸發電路獨特,控制調壓精確無滯後,接阻性負載關死為0開啟後從10V起調,調到最大接近輸入的電源電壓(此功能獨家推出,現市面上其它產品開啟電壓一般是40-60V不信可以實物一對一比較,如有特別要求從0-1-2-3起調請說明我們電路做修改就能實現,以上都是以阻性負載為調節基礎)。
  2. 可控矽增加RC吸收保護電路。
  3. 升級風扇帶開關智慧制控,散熱效果好,使用壽命長。
  4. 標配高檔精美鋁外殼更安全超實用。
  5. 升級品牌全銅75A超大電流接線柱。

硬體規格

  • 使用電壓:交流 110V-220V
  • 最大功率:10000W(接阻性負載)
  • 電壓調節:交流0V-接近輸入電壓之間可調
  • 規格尺寸:長111MM*寬77MM*37MM(不含手柄)
  • 重量:0.28KG

使用方法

  • 把可控矽調壓器接在用電器的電路前面,輸入,輸出線分別接好(不用分零火線)旋轉電位器旋杆,即可起到明暗調光、調速、調壓、調溫的作用;使用非常方便。
  • 本產品應用:使用新型雙向超大功率可控矽,可控矽標值100A,阻性負載能在0—-輸入電壓之間任意調整,供用電器使用。如:電爐,熱水器的調熱、燈具的調光、大馬達電機調速等。從而達到調光,調溫,調壓的效果。可供用電功率小於10000瓦(純阻性負載)的大型電器使用由於功率超大,所以一般的家庭電器或是小型工廠足夠用。(電感性或電容性負載啟動電流大,是平時工作2-4倍,使用時功率應降低,最好能留一半以下的餘量,)

注意事項:注意負載不能超過規定的最大功率,第一次使用要注意溫升,如果溫度很高(超過80度)還要加強處理散熱,否則會燒壞模組和用電器;使用感性、容性負載功率要大大的降低最少要留有一半以上餘量。

10000W High Power SCR Voltage Regulator Motor Speed Controller Temperature Switch Dimmer Thermostat Cooling Fan 110V 220V AC

  • Ultra-high-power electronic voltage regulator, special designed circuit, correct and accuracy control.
  • 10000W SCR voltage regulator with intelligent fan. Aluminum shell, safe and firm that you can use for a long time.
  • Add RC absorbing to protect the circuit, upgrade fan has intelligent switch control, great effect for cooling and use for a long time.
  • Connecting to resistive loas, 0V when shutting off and adjust from 10V to the maximum rate which near input power voltage when starting up.
  • Super high current terminal which is made of copper. Suitable for lighting, heating wire, heating boiler, electric motors and other tools control.

Parameter:
● Operating Voltage: AC 110V-230V.
● Maximum Power: 10000W (resistive load).
● Long Term Operating Power: 7000W.
● Voltage Adjustment: Adjustable from AC 0V to near input voltage.
● Size: 4.37×3.03×1.45 in/111×77×37 mm.
● Weight: 9.87 oz/280 g.

Features:
● The trigger circuit is unique, the control voltage is accurate and there is no hysteresis, the resistive load is turned off to 0, and after starting, it will be adjusted from 10V, adjust to the supply voltage that is closest to the input.
● SCR increases dual protection varistors and RC snubber circuit.
● Upgrade fan with switch, intelligent control, good heat dissipation effect, long service life.
● High temperature fire FR4 Circuit board.
● Standard high-grade exquisite aluminum shell is safer and more practical.
● Full copper 75A super large current terminal.

Application:
● Using the new two-way super-power SCR, the resistive load can be adjusted between 0 — input voltage for use by electrical appliances.
● Such as: Electric furnace, Water heater heating, Lighting dimming, large motor motor speed control and so on. Thereby achieving the effects of dimming, temperature regulation and voltage regulation.
● Can supply power less than 10,000 watts (resistance load) of large electrical appliances, because of the high power, so the general home appliances or small factory enough to use.

Precautions:
● The load should not exceed the specified maximum power. Pay attention to the temperature for the first use. If the temperature is high (more than 80 ℃), please enhance heatsink. Otherwise, the module and the appliance will be burned out.
● If connect to inductive load or Capacitive load, the power must leave Two-thirds (2/3) margin.

Package Included:
1 × AC 110V-220V 10000W SCR Voltage Regulator

 

商品評價

目前沒有評價。


搶先評價 “10000W超大功率可控矽電子調壓器 110V-220V電機馬達控制調速調光”

  • 本網站所提到的產品規格、應用程式、圖片及資訊僅提供參考,內容會隨時更新,恕不另行通知。
  • 商標聲明:本網站所談論到的產品名稱僅做識別之用,而這些名稱可能是屬於其他公司的註冊商標或是版權。
您已經成功購買本項商品: